What should be paid attention to in the installation of shower enclosure?

1. Preparing the simple shower room installation. Before installing the indoor bathtub, you must first prepare the materials and tools.

Material preparation: The materials used in the simple shower room installation include accessories such as frame, tempered glass, handle and pulley.

Tool preparation: In the process of simple shower room installation, a lot of tools are still needed. Before installation, it is best to prepare all these tools. The things used in this installation include tape measure, pencil, impact drill, hand hammer, electric screwdriver, glue gun, manual screwdriver, wire cutters, etc.

2. The method of fixing the structure of the simple shower room. The first step in the installation of the simple shower room is to find the position, punch the hole, and then fix the frame. There are many things needed to find positions and punch holes, and the operations are more complicated. Let's take a look at how the installation master does this step.

Determine drilling orientation: use tape measure + pen

The simple shower room needs to be fixed. The fixing method is usually to use screws. The large hole of the aluminum alloy frame on the wall has been set aside. What we need to do is to show the corresponding orientation symbol on the wall. The method is to put the frame against the wall, the tape measure to ensure the correct orientation, and then use a pencil to make a mark on the wall.

Punch: Use a hammer drill

Step 1: After setting the orientation, the next step is to punch holes. Drilling is also divided into two steps. First, use a circular impact drill to punch a shallow hole on the wall at the marked position.

Construction tips: Because the bathroom wall is now covered with wall tiles, it is relatively solid. To make drilling easier, you can wet the drill bit, and you can splash some water while drilling.

Step 2: After punching the prototype symbol hole, the next step is to use a helical drill with a stronger impact. On the basis of the shallow holes that have been drilled, drill deeper holes.

To install the pellets: use a hand hammer

Before screwing the screws into the wall, it is first necessary to expand the rubber particles in the holes, and the rubber particles can fasten the screws very well. Use a hand hammer to drive the pellets into the drilled holes.

Fixing the frame: Use an electric screwdriver

After the above steps are done, you can install the frame of the simple shower room, put the bottom frame on the water retaining strip, and then fix the frame. The way to do this is to use an electric screwdriver to drive screws into the wall and then hold the structure in place.

3. Simple shower room glass and top frame device, after fixing the frame, the next step is the glass and top frame device of the shower  base. If the installation is not careful, it is easy to cause problems such as not being able to align, leaving seams, etc.

Install tempered glass. If the glass shower stalls consist of two pieces of tempered glass and two sliding doors, after installing the bottom frame and the frame against the wall, the next step is to install two pieces of tempered glass. The tempered glass device first needs to be placed in a good position, and the next step is to fix the bottom.

The two pieces of tempered glass do not need to be moved, so they need to be fixed with accessories. The first is to use a U-shaped fitting to clamp the master, and then use pliers and a screwdriver to fix the nuts and screws that connect with the bottom structure.